TwinTurbo.NET: Nissan 300ZX forum - Bingo! (n/m)
Subject
Bingo! (n/m)
Posted by
LitlElvis
on January 10, 2019 at 11:33 PM
This message has been viewed
311
times.
In Reply To
The big round seal then. (n/m)
posted by Musashi Sword
on January 09, 2019 at 02:11 PM
Message
Follow Ups
Does anyone know what the name of the big round gasket
-
Musashi Sword
10:48:45 01/09/19
it's a seal (n/m)
-
LitlElvis
13:27:21 01/09/19
The big round seal then. (n/m)
-
Musashi Sword
14:11:20 01/09/19
Bingo! (n/m) -
LitlElvis
23:33:05 01/10/19
:) (n/m)
-
Musashi Sword
09:16:52 01/11/19
Check here
-
Polish
13:30:54 01/09/19
That's it. Rear hub, grease seal. Thanks! (n/m)
-
Musashi Sword
14:05:34 01/09/19
Where you the one that welded the rear brake mounting bracke
-
moxie (SF)
09:25:01 01/10/19
It's cast aluminum so I didn't do it. This is the second
-
Musashi Sword
10:37:57 01/10/19
Did you take the rear hub off or take the whole car someplac (n/m)
-
moxie (SF)
10:49:05 01/10/19
I got a spare set from Tim so I could do the swap at one
-
Musashi Sword
11:04:26 01/10/19
How much did the welding cost? And how much of a pita is it
-
moxie (SF)
16:00:06 01/10/19
On my blue TT it was done while the whole rear end was
-
Musashi Sword
09:16:32 01/11/19
Here it is with the rotor in place.
-
Musashi Sword
10:41:32 01/10/19
The STI brembo rears bolt on - no welding needed. (n/m)
-
Bernie (NoVA)
07:49:30 01/16/19
Jerry. (n/m)
-
Bernie (NoVA)
14:20:28 01/12/19
Can it be Tom? (n/m)
-
Musashi Sword
06:24:44 01/14/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.