TwinTurbo.NET: Nissan 300ZX forum - It's cast aluminum so I didn't do it. This is the second
Subject
It's cast aluminum so I didn't do it. This is the second
Posted by
Musashi Sword
on January 10, 2019 at 10:37 AM
This message has been viewed
273
times.
In Reply To
Where you the one that welded the rear brake mounting bracke
posted by moxie (SF)
on January 10, 2019 at 09:25 AM
Message
time I've had it done though. Did it on my old blue slicktop TT too..
Follow Ups
Does anyone know what the name of the big round gasket
-
Musashi Sword
10:48:45 01/09/19
it's a seal (n/m)
-
LitlElvis
13:27:21 01/09/19
The big round seal then. (n/m)
-
Musashi Sword
14:11:20 01/09/19
Bingo! (n/m)
-
LitlElvis
23:33:05 01/10/19
:) (n/m)
-
Musashi Sword
09:16:52 01/11/19
Check here
-
Polish
13:30:54 01/09/19
That's it. Rear hub, grease seal. Thanks! (n/m)
-
Musashi Sword
14:05:34 01/09/19
Where you the one that welded the rear brake mounting bracke
-
moxie (SF)
09:25:01 01/10/19
It's cast aluminum so I didn't do it. This is the second -
Musashi Sword
10:37:57 01/10/19
Did you take the rear hub off or take the whole car someplac (n/m)
-
moxie (SF)
10:49:05 01/10/19
I got a spare set from Tim so I could do the swap at one
-
Musashi Sword
11:04:26 01/10/19
How much did the welding cost? And how much of a pita is it
-
moxie (SF)
16:00:06 01/10/19
On my blue TT it was done while the whole rear end was
-
Musashi Sword
09:16:32 01/11/19
Here it is with the rotor in place.
-
Musashi Sword
10:41:32 01/10/19
The STI brembo rears bolt on - no welding needed. (n/m)
-
Bernie (NoVA)
07:49:30 01/16/19
Jerry. (n/m)
-
Bernie (NoVA)
14:20:28 01/12/19
Can it be Tom? (n/m)
-
Musashi Sword
06:24:44 01/14/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.