TwinTurbo.NET: Nissan 300ZX forum - I'm putting down porcelain in my new garage
Subject
I'm putting down porcelain in my new garage
Posted by
vorpalZ
on October 22, 2018 at 9:35 AM
This message has been viewed
201
times.
In Reply To
This is pretty nice.
posted by not4resaleZ
on October 20, 2018 at 10:17 AM
Message
Make sure your tile is PEI 5 for maximum durability (your tile in the link is rated PEI 4, heavy foot traffic) and the CoF is .60 or greater rated as Slip Resistant.
PEI ratings
Slip Resistance
Follow Ups
Sloped or flat garage floor? I'm thinking of putting in
-
not4resaleZ
16:35:11 10/19/18
If you have a drain going into the floor, I would think you
-
MixManMash
16:36:39 10/19/18
No drain, just slope now towards the doors. (n/m)
-
not4resaleZ
16:39:13 10/19/18
Oil based epoxy is where its at. (n/m)
-
ZXRider
18:11:32 10/19/18
hmmm - search polyaspartic (n/m)
-
ConVerTT
18:36:30 10/19/18
This. (n/m)
-
MixManMash
19:28:23 10/19/18
This is pretty nice.
-
not4resaleZ
10:17:47 10/20/18
I'm putting down porcelain in my new garage -
vorpalZ
09:35:12 10/22/18
I'm looking at these:
-
vorpalZ
09:48:08 10/22/18
Don't forget the mortar, gap and grout.... (n/m)
-
FrozTTy
12:49:11 10/24/18
I'll study this a little more. The Garage Journal guys
-
not4resaleZ
10:40:44 10/22/18
I'd be concerned about impact fracturing (n/m)
-
Gordo NA2LS Daytona
13:36:30 10/24/18
an impact great enough to shatter a high strength
-
vorpalZ
10:01:37 10/25/18
Mine is sloped 1/4ā per 8 ft....
-
ConVerTT
18:43:12 10/19/18
So, is there any advantage to that? (n/m)
-
not4resaleZ
20:32:48 10/19/18
Yes ....
-
ConVerTT
02:08:05 10/20/18
I think they do 1/8ā per foot around here.
-
not4resaleZ
09:53:29 10/20/18
per foot?? (n/m)
-
ForceFedTT
14:57:06 10/20/18
Yes. (n/m)
-
not4resaleZ
18:44:51 10/20/18
Well ...greater slope = less squeegee I imagine
-
ConVerTT
11:41:23 10/22/18
A lift would be shimmed up at the low end. It must be level (n/m)
-
Gordo NA2LS Daytona
09:35:40 10/25/18
Not for two inches. They are adjusted to the safety stops
-
ConVerTT
09:52:58 10/25/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.