TwinTurbo.NET: Nissan 300ZX forum - I had cut some of my test runs open ,
People Seeking Info
 
   


     
Subject I had cut some of my test runs open ,
     
Posted by Barry (NJ) on October 08, 2018 at 1:59 PM
  This message has been viewed 18 times.
     
In Reply To I'm sure these are fine for most applications but... posted by ZXoltan on October 08, 2018 at 07:25 AM
     
Message and the solder seemed to penetrate well. I do recommend some practice as I had over cooked a couple, and thinned/bubbled the shrink-wrap, worrying about the solder melt.

Progress, it's in...
     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.