TwinTurbo.NET: Nissan 300ZX forum - clipping on the coil pack wire works for me and the tech.
Subject
clipping on the coil pack wire works for me and the tech.
Posted by
Zjustignoreme
on May 24, 2018 at 11:59 AM
This message has been viewed
185
times.
In Reply To
The Z isn't easy to check timing on...
posted by Polish
on May 23, 2018 at 04:34 PM
Message
Loop never works. They check when I go. But Iv'e never had any issues passing without any of the tricks suggested here. No precats either.
Follow Ups
ms manifolds and egr
-
moxie (SF)
17:18:23 05/22/18
Look for a boss next to the driver side turbo flange...
-
Ted (92TT)
18:44:08 05/22/18
It should be a pretty large boss...
-
Ted (92TT)
18:46:20 05/22/18
Mike can tap them for EGR on request. (n/m)
-
Bernie (NoVA)
18:46:27 05/22/18
Awesome! Do you know how to get a hold of him by chance? (n/m)
-
moxie (SF)
19:40:04 05/22/18
Yes. (n/m)
-
Bernie (NoVA)
10:15:32 05/23/18
That is a valid answer ;-) (n/m)
-
Barry (NJ)
14:43:52 05/31/18
Most local machine shops will tap it for a small fee (n/m)
-
ZXoltan
16:51:25 05/23/18
Greg mentioned...
-
CameronSF
20:05:46 05/22/18
I assume it would pass, but not worth the headache
-
moxie (SF)
20:20:51 05/22/18
I hear you. You still in SF?
-
CameronSF
20:50:02 05/22/18
Yes and yes! Ha
-
moxie (SF)
21:00:13 05/22/18
Sounds like a plan.
-
CameronSF
10:47:26 05/23/18
Alice's cafe... on skyline blvd in woodside
-
moxie (SF)
15:22:22 05/23/18
"Next 6 miles"...
-
mysticLegoZ
14:29:23 05/27/18
There isn't much headache
-
Polish
00:06:43 05/23/18
My techs always checked timing. Has to be in spec to pass! (n/m)
-
Zjustignoreme
14:59:25 05/23/18
The Z isn't easy to check timing on...
-
Polish
16:34:13 05/23/18
clipping on the coil pack wire works for me and the tech. -
Zjustignoreme
11:59:18 05/24/18
No pre-cats should fail visual shouldn't it?
-
Polish
17:06:10 05/24/18
yes, it does, and has happened to me 2x (n/m)
-
moxie (SF)
12:48:27 05/25/18
I got lucky. He didn't check that. That is harder to see.
-
Zjustignoreme
19:18:56 05/27/18
I just cut the hard pipe really close to the manifold
-
-Grimm-
12:25:39 05/23/18
More than likely you could even get away with having
-
ZXoltan
16:50:19 05/23/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.