TwinTurbo.NET: Nissan 300ZX forum - They cut the outter edge of the bend, off the pipe.
Subject
They cut the outter edge of the bend, off the pipe.
Posted by
Aaronw
on May 11, 2018 at 1:56 PM
This message has been viewed
307
times.
In Reply To
Do most of the X pipes out there "balance" the pressures?
posted by TTkeeper
on May 11, 2018 at 11:51 AM
Message
Which gives you an oval opening. They weld those open ovals on each pipe, to each other, that makes the X pipe. You can make it a few other ways but that it the most common.
Follow Ups
How important is the H pipe on 400+rwhp Zs?
-
TTkeeper
19:56:23 05/10/18
Re: How important is the H pipe on 400+rwhp Zs?
-
Rob260
20:05:52 05/10/18
Do most of the X pipes out there "balance" the pressures?
-
TTkeeper
11:51:59 05/11/18
To my knowledge, they are open between them, mine is. (n/m)
-
Barry (NJ)
13:34:21 05/11/18
I believe Stillen X-pipe are not open & some knock offs.
-
induetime
13:55:47 05/11/18
False - the Stillen X pipe is open. That's the whole point. (n/m)
-
Bernie (NoVA)
16:14:37 05/11/18
It's harder and more expensive to join the tubes
-
BlackholeZ
20:46:55 05/11/18
They cut the outter edge of the bend, off the pipe. -
Aaronw
13:56:34 05/11/18
They should be open. Supposed to serve as a balance tube. (n/m)
-
ForceFedTT
15:13:08 05/11/18
Mark joined the forum July 21, 2000. Is this a joke? (n/m)
-
Bernie (NoVA)
16:15:35 05/11/18
Hmmm... not sure if being trolled now.... (n/m)
-
ForceFedTT
16:54:00 05/11/18
no trolling....Updated my profile too.
-
TTkeeper
19:31:11 05/11/18
No joke...had a 91 stage 4+, now have a 90 stage 5
-
TTkeeper
19:14:13 05/11/18
Try installing Synapse Engineering Branch Tee resonators on
-
MixManMash
21:15:39 05/11/18
I make 400+Rwhp and have no H or X. I’m running
-
Aaronw
13:47:35 05/11/18
You'd be better off w. a X pipe (n/m)
-
Bernie (NoVA)
16:16:11 05/11/18
Re: You'd be better off w. a X pipe
-
MikeC(NZ)
16:58:32 05/11/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.