Subject	While you're at it...
Posted by	ZXoltan on March 19, 2018 at 2:46 PM
	This message has been viewed 273 times.
In Reply To	Re: Why replace the head gasket if there is nothing wrong with posted by ouikikazz on March 19, 2018 at 01:17 PM
Message	why not just pull the pistons and hone/re-ring? and while you're at it, should probabably resize rod big end, and while you're at it, should prob check the heads and do a valve job... Which is probably why nothing is cheap when I do it, lol.
Follow Ups	Crank and rod bearing replacement - njz 16:00:23 03/16/18 Talk to Jesse, pretty sure he's done that... (n/m) - Barry (NJ) 16:52:28 03/16/18 Thank you Barry (n/m) - njz 17:02:21 03/16/18 Yep. If the engine is out, flip it over, pull the oil pan, - MixManMash 17:53:15 03/16/18 Re: Yep. If the engine is out, flip it over, pull the oil pan, - njz 18:51:26 03/16/18 Yes, it’s simple - -Grimm- 21:31:56 03/16/18 Re: Crank and rod bearing replacement - ouikikazz 13:42:57 03/17/18 Why replace the head gasket if there is nothing wrong with - MixManMash 19:56:30 03/17/18 This^ ? (n/m) - ZXoltan 08:37:37 03/18/18 Re: Why replace the head gasket if there is nothing wrong with - ouikikazz 13:17:46 03/19/18 While you're at it... - ZXoltan 14:46:33 03/19/18 You must have low oil pressure if your doing that. Make sure - CmyZ 15:20:28 03/18/18 I'll be doing the same. Motor will be out for some other - Zbullet 09:59:42 03/19/18
Post a Followup	You cannot reply to this message because you are not logged in.