Subject	I would suggest a satin black powder coat instead of
Posted by	Bernie (NoVA) on March 08, 2018 at 7:20 AM
	This message has been viewed 322 times.
In Reply To	Suggestions on OEM "correct" paint for 90 TT valve covers posted by GrecV2 on March 07, 2018 at 09:44 PM
Message	rattle can paint which will just flake off again. I have some here that are powder coated already to go w. gasket kits. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Suggestions on OEM "correct" paint for 90 TT valve covers - GrecV2 21:44:35 03/07/18 I would suggest a satin black powder coat instead of - Bernie (NoVA) 07:20:55 03/08/18 Do you have any silver P/C'd? - ZXoltan 08:00:01 03/08/18 I will 2nd that, BK (n/m) - Joe@Dewla_DeZign 20:36:05 03/09/18 I just had them strip mine with M/A (n/m) - Joe@Dewla_DeZign 20:37:47 03/09/18 How much w/ out the gasket kit? Any in a gloss black? (n/m) - CarolinaZ_TT 12:40:00 03/08/18 I might - will check (n/m) - Bernie (NoVA) 16:47:54 03/08/18 Here is what I have... - Bernie (NoVA) 09:34:53 03/10/18 Depends... - vorpalZ 10:38:41 03/08/18 Pretty sure bare alum started in 94 or 95, black b4 that (n/m) - ZXoltan 16:39:22 03/08/18 Black 90-91, raw aluminum 1992+ (n/m) - Bernie (NoVA) 10:46:17 03/09/18 This. (n/m) - MixManMash 19:13:37 03/09/18 Sounds like satin black is what I'm after... - GrecV2 11:11:39 03/08/18 Re: Suggestions on OEM "correct" paint for 90 TT valve covers - succafool 11:57:38 03/08/18 I'm almost done 'remodeling' my PC setup... - -Grimm- 13:12:50 03/08/18 If your goal is a stock look, then satin black is the best - Mike TDK (NoVA) 00:49:34 03/09/18
Post a Followup	You cannot reply to this message because you are not logged in.