I've been putting this job off as I'm not completely clear on the wiring work needed in the driver fenderwell. I want to connect the clutch pedal switch to the starter relay, so it only starts when clutch properly depressed. The write up isn't clear without the photos when it comes to this step, it just says "In the driver fender the black/white and the black/yellow wires are the ones that need to be connected. This will bypass everything. The best thing to do is to wire the clutch pedal switch into these two wires so that the starter only works with the clutch pedal pushed." I can take some photos if I can figure it out.
Also, I can't seem to find any resources about what to do with the third clutch pedal switch. It doesn't seem to be too necessary since no one mentions it, but it is there and I would like to connect it to something.