TwinTurbo.NET: Nissan 300ZX forum - Well, my initial question and first pic was
Subject
Well, my initial question and first pic was
Posted by
Barry (NJ)
on December 09, 2017 at 7:15 AM
This message has been viewed
201
times.
In Reply To
Hes asking about the spot welded tab
posted by -Grimm-
on December 08, 2017 at 01:49 PM
Message
about the spot welded tab, which has no holes at all to line up to something, so when he said he couldn't figure out what the thread holes line up to, I figured he was asking about the tab with the threaded hole...
src="https://www.flickr.com/photos/20967309@N06/6236294254/in/set-
72157622208933944/player/" width="640" height="427"
frameborder="0"
allowfullscreen webkitallowfullscreen mozallowfullscreen oallowfullscreen
msallowfullscreen>
Follow Ups
The weird little tab, welded towards the top of
-
Barry (NJ)
07:26:54 12/04/17
Picture? (n/m)
-
ZXoltan
09:42:44 12/04/17
Re: Picture...
-
Barry (NJ)
12:48:13 12/04/17
I anxiously await the answer to this question.
-
ZUL8R
17:13:59 12/04/17
Feed it through?
-
Barry (NJ)
18:51:34 12/04/17
ah.. I'm sure you're right. I just remember it being in
-
ZUL8R
20:55:51 12/04/17
It does if you assemble the entire engine and forget it ;) (n/m)
-
-Grimm-
13:21:34 12/05/17
2nd that... it won't go through with the manifold on
-
vorpalZ
16:44:57 12/05/17
Ahhh yes... AmateurZ at work... 3 steps forward
-
Barry (NJ)
10:48:19 12/09/17
Any other Nissan models use the same dipstick?
-
Zbruh92
18:36:58 12/05/17
The bracket bolts to the head, via the valve cover
-
Barry (NJ)
14:26:38 12/06/17
Picture...
-
Barry (NJ)
20:26:15 12/06/17
Hes asking about the spot welded tab
-
-Grimm-
13:49:52 12/08/17
Well, my initial question and first pic was -
Barry (NJ)
07:15:04 12/09/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.