TwinTurbo.NET: Nissan 300ZX forum - Any other Nissan models use the same dipstick?
Subject
Any other Nissan models use the same dipstick?
Posted by
Zbruh92
on December 05, 2017 at 6:36 PM
This message has been viewed
420
times.
In Reply To
The weird little tab, welded towards the top of
posted by Barry (NJ)
on December 04, 2017 at 07:26 AM
Message
I couldn’t figure it out either but it wasn’t in the way so I just ignored it. Where did u bolt the bracket to? I couldn’t find any threaded holes that lined up and sometimes it rattles against the manifold. Irritates the living shhh out of me
Follow Ups
The weird little tab, welded towards the top of
-
Barry (NJ)
07:26:54 12/04/17
Picture? (n/m)
-
ZXoltan
09:42:44 12/04/17
Re: Picture...
-
Barry (NJ)
12:48:13 12/04/17
I anxiously await the answer to this question.
-
ZUL8R
17:13:59 12/04/17
Feed it through?
-
Barry (NJ)
18:51:34 12/04/17
ah.. I'm sure you're right. I just remember it being in
-
ZUL8R
20:55:51 12/04/17
It does if you assemble the entire engine and forget it ;) (n/m)
-
-Grimm-
13:21:34 12/05/17
2nd that... it won't go through with the manifold on
-
vorpalZ
16:44:57 12/05/17
Ahhh yes... AmateurZ at work... 3 steps forward
-
Barry (NJ)
10:48:19 12/09/17
Any other Nissan models use the same dipstick? -
Zbruh92
18:36:58 12/05/17
The bracket bolts to the head, via the valve cover
-
Barry (NJ)
14:26:38 12/06/17
Picture...
-
Barry (NJ)
20:26:15 12/06/17
Hes asking about the spot welded tab
-
-Grimm-
13:49:52 12/08/17
Well, my initial question and first pic was
-
Barry (NJ)
07:15:04 12/09/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.