TwinTurbo.NET: Nissan 300ZX forum - yep
Subject
yep
Posted by
aliaZ
on December 04, 2017 at 3:23 AM
This message has been viewed
302
times.
In Reply To
There are other factors to consider beside the deck surface
posted by -Grimm-
on November 30, 2017 at 01:42 PM
Message
at a minimum, make sure the cam spins freely in cam bore (with lifters not installed, obviously). I've had came bores line honed to correct issues with binding.
Follow Ups
Any point in keeping warped heads?
-
ZUL8R
18:01:21 11/26/17
19 thou off, not 12.
-
ZUL8R
18:09:04 11/26/17
According to the FSM, not usable.
-
MixManMash
18:35:16 11/26/17
Thanks MMM. Off to the scrapper! (n/m)
-
ZUL8R
20:20:05 11/26/17
Bah
-
aliaZ
19:47:02 11/29/17
So, what's the limit then? (n/m)
-
MixManMash
07:03:56 11/30/17
There are other factors to consider beside the deck surface
-
-Grimm-
13:42:55 11/30/17
yep -
aliaZ
03:23:08 12/04/17
hard to say
-
aliaZ
03:32:41 12/04/17
You may be able to sell the cams & lifters (n/m)
-
Bernie (NoVA)
09:36:12 11/27/17
Thanks Bernie. Good save. (n/m)
-
ZUL8R
10:55:00 11/27/17
Valves worth keeping at all? (n/m)
-
Zluster
12:26:02 11/27/17
If they are not the early ones - they can be reused. (n/m)
-
Bernie (NoVA)
22:32:50 11/27/17
Am I correct in remembering the TT valves are different?
-
Zluster
11:03:56 11/29/17
If you werent so far away I would take them for R&D
-
-Grimm-
14:06:37 11/29/17
Steven, you're alive...
-
ZXoltan
09:34:53 11/30/17
Im dying slowly...
-
-Grimm-
11:01:50 11/30/17
What casting #? I'm looking for a scrap 48P (n/m)
-
LitlElvis
11:57:26 11/30/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.