Subject	What was used for the final hone work? Is the cross > >>>
Posted by	ZUL8TR on October 30, 2017 at 4:50 AM
	This message has been viewed 345 times.
In Reply To	I told my machinist I would be using MLS gaskets posted by Zbruh92 on October 29, 2017 at 09:27 AM
Message	hatch angle angle at about 23 degrees to horizontal on up hatch lines and down hatch lines for about 45 total angle between as recommended? Doesn't look like it in the pics. What are the vertical lines in cylinder lower left? Were the bore center-lines checked to be 90 degrees to the block surface before resurfacing? Did you check for block flatness in all directions with a back light and a machinist's flatness standard straight edge? I use back light and feeler and it tells me a lot more on flatness. ZUL8TR
Follow Ups	Cometic gasket question... - Zbruh92 19:53:09 10/28/17 I hope the surfaces are machined perfectly. MLS - MixManMash 01:29:26 10/29/17 I told my machinist I would be using MLS gaskets - Zbruh92 09:27:34 10/29/17 What was used for the final hone work? Is the cross > >>> - ZUL8TR 04:50:48 10/30/17 Where’d you source those recommended hatching angles? - Zbruh92 08:01:04 10/30/17 Re: Where’d you source those recommended hatching angles? - ZUL8TR 13:10:00 10/30/17 Actually... - Zbruh92 08:24:23 10/30/17 Any particular reason for not going OEM? +1000whp? (n/m) - puchy 12:10:44 10/29/17 Gasket thickness was my primary concern - Zbruh92 16:09:37 10/29/17 I think that you may have some other issue, not the HG. - puchy 21:11:44 10/29/17 So I can run an oem gasket with 0.040” over? - Zbruh92 22:08:18 10/29/17 I have everyday @570 whp for the last 4 years. 88mm pistons. - puchy 22:51:21 10/29/17 I’ll keep that in mind should these fail Lol - Zbruh92 00:32:36 10/30/17 I've never understood the hype for these headgaskets... - Stanky (BC) 12:36:49 10/29/17 Your absolutely right but - Zbruh92 16:15:39 10/29/17 Fair, but why try to fix something that's not broken? - Stanky (BC) 18:31:18 10/29/17 I don’t think I can run OEM hg with an 88mm bore - Zbruh92 21:47:28 10/29/17 OEM HG definitely good for 88mm - ZXoltan 16:45:03 10/30/17 monkey see, monkey do..... - LJZTT 17:53:30 10/31/17 I bought cometic ... disappointed with fitment - Zbullet 21:38:48 10/29/17 I had no issues with the fitment - Zbruh92 23:05:15 10/29/17 Re: Cometic gasket question... - Rob260 22:25:08 10/29/17 Ultimately it comes down to preparation - Zbruh92 23:58:54 10/29/17 Why did you even bother to ask ...? - ZXoltan 16:48:37 10/30/17 What’s left of the VIN... - Zbruh92 00:55:25 10/30/17
Post a Followup	You cannot reply to this message because you are not logged in.