TwinTurbo.NET: Nissan 300ZX forum - I had no issues with the fitment
Subject
I had no issues with the fitment
Posted by
Zbruh92
on October 29, 2017 at 11:05 PM
This message has been viewed
262
times.
In Reply To
I bought cometic ... disappointed with fitment
posted by Zbullet
on October 29, 2017 at 09:38 PM
Message
There’s no turning back now I’ll have it running by the end of week. I’ll post the results, I went all out on prep prior to installation so if they fail the gaskets are at fault and the rumors are true
Follow Ups
Cometic gasket question...
-
Zbruh92
19:53:09 10/28/17
I hope the surfaces are machined perfectly. MLS
-
MixManMash
01:29:26 10/29/17
I told my machinist I would be using MLS gaskets
-
Zbruh92
09:27:34 10/29/17
What was used for the final hone work? Is the cross > >>>
-
ZUL8TR
04:50:48 10/30/17
Where’d you source those recommended hatching angles?
-
Zbruh92
08:01:04 10/30/17
Re: Where’d you source those recommended hatching angles?
-
ZUL8TR
13:10:00 10/30/17
Actually...
-
Zbruh92
08:24:23 10/30/17
Any particular reason for not going OEM? +1000whp? (n/m)
-
puchy
12:10:44 10/29/17
Gasket thickness was my primary concern
-
Zbruh92
16:09:37 10/29/17
I think that you may have some other issue, not the HG.
-
puchy
21:11:44 10/29/17
So I can run an oem gasket with 0.040” over?
-
Zbruh92
22:08:18 10/29/17
I have everyday @570 whp for the last 4 years. 88mm pistons.
-
puchy
22:51:21 10/29/17
I’ll keep that in mind should these fail Lol
-
Zbruh92
00:32:36 10/30/17
I've never understood the hype for these headgaskets...
-
Stanky (BC)
12:36:49 10/29/17
Your absolutely right but
-
Zbruh92
16:15:39 10/29/17
Fair, but why try to fix something that's not broken?
-
Stanky (BC)
18:31:18 10/29/17
I don’t think I can run OEM hg with an 88mm bore
-
Zbruh92
21:47:28 10/29/17
OEM HG definitely good for 88mm
-
ZXoltan
16:45:03 10/30/17
monkey see, monkey do.....
-
LJZTT
17:53:30 10/31/17
I bought cometic ... disappointed with fitment
-
Zbullet
21:38:48 10/29/17
I had no issues with the fitment -
Zbruh92
23:05:15 10/29/17
Re: Cometic gasket question...
-
Rob260
22:25:08 10/29/17
Ultimately it comes down to preparation
-
Zbruh92
23:58:54 10/29/17
Why did you even bother to ask ...?
-
ZXoltan
16:48:37 10/30/17
What’s left of the VIN...
-
Zbruh92
00:55:25 10/30/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.