Subject	I told my machinist I would be using MLS gaskets
Posted by	Zbruh92 on October 29, 2017 at 9:27 AM
	This message has been viewed 371 times.
In Reply To	I hope the surfaces are machined perfectly. MLS posted by MixManMash on October 29, 2017 at 01:29 AM
Message	I feel good about the results the heads had a mirror-like finish. Here’s the block, can’t find head pics unfortunately. https://www.dropbox.com/s/z3ik1nl9y15jb4f/Photo%20Sep%2001%2C%206%2029%2055%20PM.jpg?dl=0 https://www.dropbox.com/s/nz0y05sngusg19i/Photo%20Aug%2009%2C%2011%2034%2018%20AM.jpg?dl=0
Follow Ups	Cometic gasket question... - Zbruh92 19:53:09 10/28/17 I hope the surfaces are machined perfectly. MLS - MixManMash 01:29:26 10/29/17 I told my machinist I would be using MLS gaskets - Zbruh92 09:27:34 10/29/17 What was used for the final hone work? Is the cross > >>> - ZUL8TR 04:50:48 10/30/17 Where’d you source those recommended hatching angles? - Zbruh92 08:01:04 10/30/17 Re: Where’d you source those recommended hatching angles? - ZUL8TR 13:10:00 10/30/17 Actually... - Zbruh92 08:24:23 10/30/17 Any particular reason for not going OEM? +1000whp? (n/m) - puchy 12:10:44 10/29/17 Gasket thickness was my primary concern - Zbruh92 16:09:37 10/29/17 I think that you may have some other issue, not the HG. - puchy 21:11:44 10/29/17 So I can run an oem gasket with 0.040” over? - Zbruh92 22:08:18 10/29/17 I have everyday @570 whp for the last 4 years. 88mm pistons. - puchy 22:51:21 10/29/17 I’ll keep that in mind should these fail Lol - Zbruh92 00:32:36 10/30/17 I've never understood the hype for these headgaskets... - Stanky (BC) 12:36:49 10/29/17 Your absolutely right but - Zbruh92 16:15:39 10/29/17 Fair, but why try to fix something that's not broken? - Stanky (BC) 18:31:18 10/29/17 I don’t think I can run OEM hg with an 88mm bore - Zbruh92 21:47:28 10/29/17 OEM HG definitely good for 88mm - ZXoltan 16:45:03 10/30/17 monkey see, monkey do..... - LJZTT 17:53:30 10/31/17 I bought cometic ... disappointed with fitment - Zbullet 21:38:48 10/29/17 I had no issues with the fitment - Zbruh92 23:05:15 10/29/17 Re: Cometic gasket question... - Rob260 22:25:08 10/29/17 Ultimately it comes down to preparation - Zbruh92 23:58:54 10/29/17 Why did you even bother to ask ...? - ZXoltan 16:48:37 10/30/17 What’s left of the VIN... - Zbruh92 00:55:25 10/30/17
Post a Followup	You cannot reply to this message because you are not logged in.