Subject	Well done, it gets only slightly easier the next time
Posted by	shaggee on October 04, 2017 at 8:04 AM
	This message has been viewed 540 times.
In Reply To	First time ever porting cylinder heads for my friends 300zx posted by EVLTWINZ on October 04, 2017 at 02:17 AM
Message	Since you are porting another set consider a more rounded edge on the intake divider. What they call a bull nose. Also on the exhaust side I usually add a gentle ramp to the tops of the guide bosses. Your bowl work looks great. Is the exhaust ported to an aftermarket manifold? Are you going to touch the chambers next time?
Follow Ups	First time ever porting cylinder heads for my friends 300zx - EVLTWINZ 02:17:38 10/04/17 Well done, it gets only slightly easier the next time - shaggee 08:04:40 10/04/17 Re: Well done, it gets only slightly easier the next time - EVLTWINZ 08:19:41 10/04/17 Re: Re: Well done, it gets only slightly easier the next time - shaggee 11:34:01 10/04/17 noice! (n/m) - LJZTT 10:56:03 10/04/17 Any chance of flow numbers? - -Grimm- 12:09:31 10/04/17 Re: Any chance of flow numbers? - Kvert 18:00:36 10/04/17 I use a Eastwood engine porting kit, a HF kit (bigger rolls) - Aaronw 21:44:13 10/06/17 Great work! - RobZ32 12:20:55 10/04/17
Post a Followup	You cannot reply to this message because you are not logged in.