TwinTurbo.NET: Nissan 300ZX forum - If I recall correctly, about 89mm, but would have to measure
Subject
If I recall correctly, about 89mm, but would have to measure
Posted by
ZXoltan
on September 29, 2017 at 8:33 AM
This message has been viewed
298
times.
In Reply To
What if cylinders were bored?
posted by Placuch
on September 28, 2017 at 08:15 PM
Message
to be sure.
Follow Ups
Which head gaskets do you prefer
-
-Grimm-
13:38:03 09/28/17
We only use OEM head gaskets, even on Greg's beast. (n/m)
-
Jonathan (Specialty Z)
14:08:34 09/28/17
I haven't had a head gasket fail.
-
MixManMash
16:57:14 09/28/17
3rd on OEM (n/m)
-
Stanky (BC)
18:31:15 09/28/17
What if cylinders were bored?
-
Placuch
20:15:35 09/28/17
If I recall correctly, about 89mm, but would have to measure -
ZXoltan
08:33:11 09/29/17
Mitch @ EP racing did a head gasket write up
-
Zbullet
20:32:40 09/28/17
A couple of things.
-
MixManMash
07:07:54 09/29/17
I'll find out if the cometic is going to cause me problems
-
Zbullet
18:50:53 09/29/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.