Subject	Mitch @ EP racing did a head gasket write up
Posted by	Zbullet on September 28, 2017 at 8:32 PM
	This message has been viewed 505 times.
In Reply To	Which head gaskets do you prefer posted by -Grimm- on September 28, 2017 at 01:38 PM
Message	I'm sure that is posted on his website. I bought a cometic for the motor I'm currently working on. The main reason was to get a custom thickness to compensate for shaving the heads a fair amount. I was disappointed with the fitment. Coolant passages on the Comtic MLS didn't match up to the passages in the block and the holes were significantly smaller than the OEM HG. I have a few pictures posted on the tech page. Cometic wasnt much help. I've been told that the MLX are a good quality HG but they are not produced for the Z32. Tomei is Mitch's preferred HG but it's damn expensive.
Follow Ups	Which head gaskets do you prefer - -Grimm- 13:38:03 09/28/17 We only use OEM head gaskets, even on Greg's beast. (n/m) - Jonathan (Specialty Z) 14:08:34 09/28/17 I haven't had a head gasket fail. - MixManMash 16:57:14 09/28/17 3rd on OEM (n/m) - Stanky (BC) 18:31:15 09/28/17 What if cylinders were bored? - Placuch 20:15:35 09/28/17 If I recall correctly, about 89mm, but would have to measure - ZXoltan 08:33:11 09/29/17 Mitch @ EP racing did a head gasket write up - Zbullet 20:32:40 09/28/17 A couple of things. - MixManMash 07:07:54 09/29/17 I'll find out if the cometic is going to cause me problems - Zbullet 18:50:53 09/29/17
Post a Followup	You cannot reply to this message because you are not logged in.