TwinTurbo.NET: Nissan 300ZX forum - Exactly what I did 7 years ago when I prepped my slicktop
Subject
Exactly what I did 7 years ago when I prepped my slicktop
Posted by
black300zx
on August 14, 2017 at 9:20 AM
This message has been viewed
403
times.
In Reply To
Question
posted by EVLTWINZ
on August 13, 2017 at 09:43 PM
Message
7 years later, no issues from using the SEM self etching primer. The car isn't garaged, so it sits outside year round under a cover.
Follow Ups
Primer question
-
Bigmatthew86
09:10:30 08/12/17
Re: Primer question
-
ZXoltan
12:54:16 08/13/17
Re: Re: Primer question
-
Bigmatthew86
15:27:13 08/13/17
I would just epoxy it.
-
Aaronw
20:04:00 08/13/17
Question
-
EVLTWINZ
21:43:10 08/13/17
Re: Question
-
Bigmatthew86
07:46:31 08/14/17
Re: Re: Question
-
EVLTWINZ
12:16:41 08/14/17
Exactly what I did 7 years ago when I prepped my slicktop -
black300zx
09:20:07 08/14/17
Re: Primer question
-
Bigmatthew86
16:02:50 08/14/17
As long as your going single stage, the 400 should be fine
-
ZXoltan
21:38:30 08/14/17
Also, if going metallic I would consider B/C rather than SS (n/m)
-
ZXoltan
08:18:20 08/15/17
Re: Also, if going metallic I would consider B/C rather than SS
-
Bigmatthew86
09:22:12 08/15/17
You don't say anything about "block sanding" the car
-
i-xclr8
20:24:35 08/18/17
Re: You don't say anything about "block sanding" the car
-
Bigmatthew86
11:30:11 08/19/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.