TwinTurbo.NET: Nissan 300ZX forum - Do you have an assembled bottom end?
People Seeking Info
 
   


     
Subject Do you have an assembled bottom end?
     
Posted by Doug71zt(CAN) on May 21, 2017 at 1:01 AM
  This message has been viewed 233 times.
     
In Reply To On some, only difference is the starter pad. posted by Doug71zt(CAN) on May 20, 2017 at 11:18 PM
     
Message You can put a flywheel on and mount the BH on the engine, then measure the distance between a straightedge across the starter pad and the ring gear outer diameter. That will tell you if the two BH are the same.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.