Subject	I'm new here so I'm not 100%
Posted by	Vicious_boost on May 20, 2017 at 9:19 PM
	This message has been viewed 268 times.
In Reply To	Looking for NA and TT bell-housing measurements. posted by Halo TTZ on May 20, 2017 at 11:30 AM
Message	But I heard the bell housing is different but the inside is the same. I saw no one has messaged back so I would rather say something in response than just watching it go without a response.
Follow Ups	Looking for NA and TT bell-housing measurements. - Halo TTZ 11:30:13 05/20/17 I'm new here so I'm not 100% - Vicious_boost 21:19:33 05/20/17 On some, only difference is the starter pad. - Doug71zt(CAN) 23:18:35 05/20/17 Do you have an assembled bottom end? - Doug71zt(CAN) 01:01:39 05/21/17 It's not much - BlackholeZ 00:18:26 05/21/17 Here's a helpful link I used when keeping my NA trans - PiotrC70 19:24:45 05/21/17 Measure how thick the starter flange is. TT is thicker - Bernie (NoVA) 16:18:48 05/22/17 gotcha! (n/m) - Halo TTZ 21:19:32 05/22/17 Gotcha boyeeeee - Guapo 22:51:37 05/22/17 boom!!!!!!! - Halo TTZ 16:24:13 05/23/17 ! (n/m) - Bernie (NoVA) 10:05:27 05/25/17
Post a Followup	You cannot reply to this message because you are not logged in.