TwinTurbo.NET: Nissan 300ZX forum - Re: Re: Re: Why? Use a caliper that was used w. a 114.3, 66.1 bore rotor
People Seeking Info
 
   


     
Subject Re: Re: Re: Why? Use a caliper that was used w. a 114.3, 66.1 bore rotor
     
Posted by Danbarnett123 on March 17, 2017 at 7:54 PM
  This message has been viewed 357 times.
     
In Reply To Re: Re: Why? Use a caliper that was used w. a 114.3, 66.1 bore rotor posted by Bad Fish on March 17, 2017 at 07:46 PM
     
Message Ideally I would run a 17z rear kit as well to keep bias correct, but I haven't seen many adapters for those. That's why I would only want to go 13" (330mm) up front as a maximum, I know it is very common to have 14" fronts and a larger rear as well, but that nearly doubles the kit cost.

The way I see it, I am due to replace the current brake pads and rotors, so for a fraction more why not upgrade everything.

I like that I can get 17z calipers cheap, so I am using that as a starting point.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.