Subject	The CNC'd 60mm.
Posted by	MixManMash on December 14, 2016 at 11:09 PM
	This message has been viewed 196 times.
In Reply To	RobZ TB's: 54 mm stock overbore or 60mm CNC'd? posted by ZXoltan on December 14, 2016 at 03:49 PM
Message	FWIW, I never had issue with my set of Z1s.
Follow Ups	Wanted to get some opions on my valves... - platinumist 17:19:53 12/12/16 After working on 2 installations of the Rob Z throttle - MixManMash 17:44:40 12/12/16 Have this been mentioned to ROB the slack / slop - CmyZ 19:13:49 12/12/16 Yep. I know SZ has mentioned it to him. (n/m) - MixManMash 23:09:15 12/12/16 Maybe a small shim can fix the issue. I have two sets - CmyZ 16:06:31 12/13/16 I do have a similar issue I believe - komplexZTT 19:46:12 12/12/16 Yep, that's the symptom. Definitely the slop between the - MixManMash 23:10:52 12/12/16 Was thinking of wrapping the shaft with something - komplexZTT 08:50:16 12/13/16 we had to do that on my set for Silver Zed - vorpalZ 09:28:10 12/13/16 Teflon tape worked genius, thanks! - komplexZTT 20:16:51 12/16/16 RobZ TB's: 54 mm stock overbore or 60mm CNC'd? - ZXoltan 15:49:46 12/14/16 The CNC'd 60mm. - MixManMash 23:09:22 12/14/16 I chased grey smoke on decel for 6 months - BlackholeZ 01:39:36 12/13/16 depending on how far u decided to go with the vavles - LivinTheDream 22:25:04 12/14/16
Post a Followup	You cannot reply to this message because you are not logged in.