Subject	Re: cranking compression typically suffers a bit with big cams
Posted by	BLACKBEAST on September 25, 2016 at 1:14 AM
	This message has been viewed 235 times.
In Reply To	cranking compression typically suffers a bit with big cams posted by LitlElvis on September 23, 2016 at 02:54 PM
Message	yes it changes a lot . I'm just over 150 across the board with 9.5 comp and 264/9.5 jun cams . . new engine. put stock cams in and that will significantly jump up
Follow Ups	what do you think of numbers? - nissan300zxwork 20:05:53 09/21/16 Those are the number I got from my new IPP block - Stanky 20:14:48 09/21/16 You'll be fine. - white22sky 20:44:19 09/21/16 those are fine (n/m) - aliaZ 22:17:51 09/21/16 ygm (n/m) - LJZTT 17:30:46 09/23/16 I'm assuming those 900 miles were stop and go. (n/m) - ForceFedTT (SoCal) 03:28:37 09/22/16 yes. (n/m) - nissan300zxwork 05:49:46 09/22/16 Re: what do you think of numbers? - cgrover300 05:43:32 09/22/16 Similar to mine, see profile for build info. (n/m) - J-Mart 14:30:34 09/22/16 Numbers look good - ZXRider 15:33:43 09/22/16 so couldnt boost over 14psi - nissan300zxwork 23:50:29 09/22/16 Those numbers look OK for a TT. The NA compression >> - ZUL8TR 04:44:58 09/23/16 Interesting that built 8.5:1 engines < stock comp #'s - ZXoltan 10:20:47 09/23/16 Forged pistons require more clearance. That would likely - MixManMash 08:15:35 09/24/16 The piston rings contain the pressure, not the piston - ZXoltan 08:48:17 09/24/16 cranking compression typically suffers a bit with big cams - LitlElvis 14:54:40 09/23/16 This. (n/m) - MixManMash 19:08:33 09/23/16 Agreed, Brett, but what about forged motors w stock cams? (n/m) - ZXoltan 08:45:45 09/24/16 Re: cranking compression typically suffers a bit with big cams - BLACKBEAST 01:14:30 09/25/16
Post a Followup	You cannot reply to this message because you are not logged in.