Subject	hopefully this post helps someone
Posted by	nissan300zxwork on August 17, 2016 at 7:45 PM
	This message has been viewed 407 times.
In Reply To	You're the 2nd person in a month that's done this... posted by LitlElvis on August 17, 2016 at 06:59 PM
Message	Man i wish i saw those photos before... Funny i stopped tightening an took cam back off cause felt wierd an was going to call z1 but looking at dowel pin an stuff i just figure tightening bolt would pull gear into place. I was wrong lol. Acted like a puller... Gear tightened to the head and bolt pulled cam into the gear.... Live an learn i guess
Follow Ups	solid lifters with any cam - nissan300zxwork 22:58:25 08/16/16 I have Solid lifter Tomei cams - Carlos Ramirez 07:46:04 08/17/16 you can just add gears for vtc - nissan300zxwork 08:21:30 08/17/16 VTC doesn't work - Carlos Ramirez 08:56:46 08/17/16 does your bolt for cam gear have a hole in center? - nissan300zxwork 09:05:40 08/17/16 don't remember .. - Carlos Ramirez 09:31:24 08/17/16 good news for you, your cams work for vtc - nissan300zxwork 10:32:21 08/17/16 Re: good news for you, your cams work for vtc - Carlos Ramirez 10:42:25 08/17/16 cam gears were about $500. vtc solenoid an button less $100 - nissan300zxwork 10:46:37 08/17/16 specialty z said intense gains with vtc. (n/m) - nissan300zxwork 10:48:34 08/17/16 I believe there is a plug in the front of "non-VTC" cams - LitlElvis 11:40:53 08/17/16 where did you buy those cams? - nissan300zxwork 08:34:23 08/17/16 figured it out - nissan300zxwork 11:14:13 08/17/16 You're the 2nd person in a month that's done this... - LitlElvis 18:59:11 08/17/16 hopefully this post helps someone - nissan300zxwork 19:45:35 08/17/16
Post a Followup	You cannot reply to this message because you are not logged in.