Subject	Re: good news for you, your cams work for vtc
Posted by	Carlos Ramirez on August 17, 2016 at 10:42 AM
	This message has been viewed 457 times.
In Reply To	good news for you, your cams work for vtc posted by nissan300zxwork on August 17, 2016 at 10:32 AM
Message	my email is my profile.. But as the Tomei cams I remember there was a lot of them there was 256 8.5mm 260 8.8mm 270 8.8mm ===== Solid Lifter Cams ==== 260 9.25mm solid cam 260 9.25mm solid cam 270 10.25 solid cam I believe that there is actually 2 type of base grinds solid and non.. Either I really want VTC so I can get some vacuum and low end back into the car. I may call Kyle and etc but right now I am in the mood to pull the the engine apart :-) My recommendation still stands go with VTC gears :-) src="http://pages.prodigy.net/carlosrg/sig05.jpg" BORDER=0>
Follow Ups	solid lifters with any cam - nissan300zxwork 22:58:25 08/16/16 I have Solid lifter Tomei cams - Carlos Ramirez 07:46:04 08/17/16 you can just add gears for vtc - nissan300zxwork 08:21:30 08/17/16 VTC doesn't work - Carlos Ramirez 08:56:46 08/17/16 does your bolt for cam gear have a hole in center? - nissan300zxwork 09:05:40 08/17/16 don't remember .. - Carlos Ramirez 09:31:24 08/17/16 good news for you, your cams work for vtc - nissan300zxwork 10:32:21 08/17/16 Re: good news for you, your cams work for vtc - Carlos Ramirez 10:42:25 08/17/16 cam gears were about $500. vtc solenoid an button less $100 - nissan300zxwork 10:46:37 08/17/16 specialty z said intense gains with vtc. (n/m) - nissan300zxwork 10:48:34 08/17/16 I believe there is a plug in the front of "non-VTC" cams - LitlElvis 11:40:53 08/17/16 where did you buy those cams? - nissan300zxwork 08:34:23 08/17/16 figured it out - nissan300zxwork 11:14:13 08/17/16 You're the 2nd person in a month that's done this... - LitlElvis 18:59:11 08/17/16 hopefully this post helps someone - nissan300zxwork 19:45:35 08/17/16
Post a Followup	You cannot reply to this message because you are not logged in.