Subject	Re: Engine re-assembly of stock short block. Tips and tricks??
Posted by	dfenton2 on July 30, 2016 at 1:14 PM
	This message has been viewed 355 times.
In Reply To	Engine re-assembly of stock short block. Tips and tricks?? posted by LivinTheDream on July 30, 2016 at 10:52 AM
Message	The engine rotating assembly will wear slightly even if everything is still good. You will more than likely be alright with factory spec bearings but it never hurts to double check just to be sure. It would be a terrible feeling if your bearings were a little loose and pouring oil causing lower than desired oil pressure.
Follow Ups	Engine re-assembly of stock short block. Tips and tricks?? - LivinTheDream 10:52:53 07/30/16 Re: Engine re-assembly of stock short block. Tips and tricks?? - dfenton2 13:14:36 07/30/16 Don't connect the washer bottle hose to the balance tube. (n/m) - Bernie (NoVA) 19:18:49 07/30/16 I actually loled, if I was drinking something it would - en5 20:36:08 07/30/16 /hydro lock. (n/m) - Bernie (NoVA) 06:51:10 07/31/16 I've seen it happen before... - MixManMash 09:11:25 07/31/16 made the damndest gurgling sound (n/m) - vorpalZ 08:41:26 08/01/16 whats a good cylinder bore gauge??? (n/m) - LivinTheDream 12:30:32 07/31/16 Mitutoyo, Starrett? (n/m) - -Grimm- 15:43:23 07/31/16
Post a Followup	You cannot reply to this message because you are not logged in.