Subject	Engine re-assembly of stock short block. Tips and tricks??
Posted by	LivinTheDream on July 30, 2016 at 10:52 AM
	This message has been viewed 394 times.
Message	Mainly curious how important it is to check all the specs and clearances. If im just pulling it down and swapping bearings and rings. There was no engine knock or anything like that why its being rebuilt. So can I just go with the specs on the crank?? "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Engine re-assembly of stock short block. Tips and tricks?? - LivinTheDream 10:52:53 07/30/16 Re: Engine re-assembly of stock short block. Tips and tricks?? - dfenton2 13:14:36 07/30/16 Don't connect the washer bottle hose to the balance tube. (n/m) - Bernie (NoVA) 19:18:49 07/30/16 I actually loled, if I was drinking something it would - en5 20:36:08 07/30/16 /hydro lock. (n/m) - Bernie (NoVA) 06:51:10 07/31/16 I've seen it happen before... - MixManMash 09:11:25 07/31/16 made the damndest gurgling sound (n/m) - vorpalZ 08:41:26 08/01/16 whats a good cylinder bore gauge??? (n/m) - LivinTheDream 12:30:32 07/31/16 Mitutoyo, Starrett? (n/m) - -Grimm- 15:43:23 07/31/16
Post a Followup	You cannot reply to this message because you are not logged in.