Subject	Do you just want measurements?
Posted by	bartz32tt on July 22, 2016 at 10:31 PM
	This message has been viewed 311 times.
In Reply To	Anyone have a template for an aftermarket oil cooler posted by Barry (NJ) on July 22, 2016 at 07:39 PM
Message	I did mine myself out of sheet aluminum. It was pretty straight forward, just use a scribe and a precise ruler. ________________Sig Separator________________________ ATTN: Zuberman The above message is not sponsored by my employer. Selling used ACT full-face sprung clutch kit: $300 + shipping ConUS! Chrome "boost" hardpipes and couplers/clamps $100 + shipping Twin Turbo aluminum front calipers: $200 + shipping. Needs paint or will paint red for additional $50 Parting out my entire 1990 twin turbo! Please email me for needed parts! See profile for my WTB/WTT list as well.
Follow Ups	Anyone have a template for an aftermarket oil cooler - Barry (NJ) 19:39:48 07/22/16 Do you just want measurements? - bartz32tt 22:31:28 07/22/16 Measurements would be good, a diagram with measurements - Barry (NJ) 22:53:53 07/22/16 Sorry for delay. Emailed you. - bartz32tt 16:25:56 07/24/16 Thanks Justin, I appreciate the effort! The measurements I'm - Barry (NJ) 09:09:52 07/25/16 Oppaman came to the rescue. - Barry (NJ) 20:34:04 07/23/16 I WJ cut mine here at work a few years ago. I can try - J-Mart 17:05:41 07/25/16 Thanks Jared, I should have mine done before Friday. (n/m) - Barry (NJ) 13:34:06 07/26/16
Post a Followup	You cannot reply to this message because you are not logged in.