TwinTurbo.NET: Nissan 300ZX forum - Enthusiasm = 10, technical accuracy = 0, humility = -10
People Seeking Info
 
   


     
Subject Enthusiasm = 10, technical accuracy = 0, humility = -10
     
Posted by LitlElvis on July 22, 2016 at 1:42 PM
  This message has been viewed 544 times.
     
In Reply To Hockey puck motor mounts posted by 1308cats on July 21, 2016 at 05:28 PM
     
Message I'll give anyone credit for thinking about how to make something better, or to save money, and/or to simply take the pride of saying "I did it." But your communication of this idea leaves a lot of critical details out for someone else to successfully duplicate, for example:

1) does this assembly affect the engine height?

2) how long is the stud?

3) does welding a threaded stud weaken it?

You obviously have some knowledge of machining/fabrication principles, thread sizes, and how to read a tape measure, but if this is as simple and cheap as you say, then make a set and show us how right you are. If you can't do that, you're going to find TT.net to be a tough crowd to earn respect from.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.