Subject	Another possible fix
Posted by	lymon on June 21, 2016 at 12:34 AM
	This message has been viewed 684 times.
In Reply To	possible Oil pressure sensor fix posted by njz on June 20, 2016 at 06:49 AM
Message	In the picture you can see how it works, the contact-arms (yellow circles) slide over the resistor wire (red arrow) which will send the signal to the gauge in the dashboard Over time the little contact-arms get bend slightly and it will loose contact with the resistor-wire. By simply bending the arm(s) back and clean the resistor-wire with contact cleaner, you can restore the sensor. I have disassembled and rebuild/repaired a few oil-pressure sensors this way.
Follow Ups	possible Oil pressure sensor fix - njz 06:49:23 06/20/16 I can't recall but isn't there already a ground wire in the - PiotrC70 08:18:30 06/20/16 It's a single wire connector - -Grimm- 09:07:45 06/20/16 ah, okay... I couldn't remember if it was a two prong sensor (n/m) - PiotrC70 09:44:25 06/20/16 2 prong sensor, but it only uses one. (n/m) - Woody75 (Denver) 11:03:33 06/20/16 So a little silicone on those threads would be a bad idea ? - ConVerTT 08:34:49 06/21/16 Nissan used a white teflon paste. - Bernie (NoVA) 11:26:13 06/21/16 Thx for posting...might be easier to attach a worm gear type - jzack 17:02:50 06/20/16 Re: Thx for posting...might be easier to attach a worm gear type - MaxxAction 21:41:42 06/20/16 I've never changed mine in 12 years/80k it still works fine. (n/m) - Bernie (NoVA) 21:53:39 06/20/16 mine is 16 years old and now is working again. (n/m) - njz 16:11:06 06/21/16 What was it doing before? (n/m) - FrozTTy 09:58:58 06/22/16 Re: What was it doing before? - njz 17:31:25 06/23/16 25 yrs... 80k no problems. (n/m) - not4resaleZ 18:04:19 06/21/16 lol wut? (n/m) - LJZTT 15:31:31 06/21/16 OEM sensors? (n/m) - BoneZ (MD) 22:25:59 06/21/16 Another possible fix - lymon 00:34:02 06/21/16 How'd you take that apart, and put back together - FrozTTy 07:35:18 06/21/16 The edge is crimped - pried it out. (n/m) - Bernie (NoVA) 09:41:56 06/21/16 pry the edges and desolder 2 wires - lymon 12:19:11 06/21/16
Post a Followup	You cannot reply to this message because you are not logged in.