Subject	Re: I don't know how the manual calls to measure it
Posted by	Buckaroo Banzai on June 12, 2016 at 11:25 AM
	This message has been viewed 416 times.
In Reply To	I don't know how the manual calls to measure it posted by -Grimm- on June 10, 2016 at 08:59 PM
Message	Thank you for the input, I should be able to do that. I was measuring from the center of the cam journal but the measurement listed in my manual can't be right if that is the proper method. I will post up what it says when I get out to the shop so hopefully someone can comment on its accuaracy.
Follow Ups	Question regarding determining if a head has been milled. - Buckaroo Banzai 12:30:25 06/10/16 I don't know how the manual calls to measure it - -Grimm- 20:59:54 06/10/16 Re: I don't know how the manual calls to measure it - Buckaroo Banzai 11:25:57 06/12/16
Post a Followup	You cannot reply to this message because you are not logged in.