Subject	I have new in stock, or I can rebuild and send them.
Posted by	Bernie (NoVA) on June 05, 2016 at 2:29 AM
	This message has been viewed 466 times.
In Reply To	best options for replacing front lower control arm bushing? posted by ZEngineer on June 04, 2016 at 12:01 AM
Message	FWIW I have genuine Nissan NOK ball joints. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	best options for replacing front lower control arm bushing? - ZEngineer 00:01:04 06/04/16 IIRC, the only hard part about the front lower control arm - Polish 12:07:12 06/04/16 I always just torch em out. (n/m) - white22sky 12:48:15 06/04/16 yep, hole saw, torch, then wire brush on a drill. (n/m) - Schmeal (NV) 20:12:28 06/04/16 Thanks guys. The reason I thought it was difficult is - ZEngineer 21:14:13 06/04/16 FLCA option - ZonaZ 13:02:03 06/04/16 Thanks John - ZEngineer 21:12:59 06/04/16 ball joints need to be pressed out/in. (n/m) - Bernie (NoVA) 02:27:59 06/05/16 I figured as much, was referring to the amount of hammering - ZEngineer 03:01:46 06/05/16 Use the right tool for the job: - MixManMash 09:39:14 06/05/16 yup, will use a puller so I don't have to replace - ZEngineer 11:52:41 06/05/16 I have new in stock, or I can rebuild and send them. - Bernie (NoVA) 02:29:03 06/05/16 Does the ball joint come out of the knuckle easily? - ZEngineer 02:58:36 06/05/16 One you remove the castle nut the ball joint/arm should drop - white22sky 21:53:31 06/05/16 Thanks! That's what I needed to hear to get me - ZEngineer 21:06:24 06/07/16
Post a Followup	You cannot reply to this message because you are not logged in.