Subject	Not even close.
Posted by	Goldchocobo on March 15, 2016 at 1:18 AM
	This message has been viewed 307 times.
In Reply To	total loss? (see pics) posted by Jiro on March 14, 2016 at 05:38 PM
Message	Pound it out from the inside, then massage the metal to get it as close as possible. After this, apply a skim coat of filler (Evercoat, no bondo plz) and block it to shape with 80 grit, finishing with 180 grit. Primer, repaint, boom, done.
Follow Ups	total loss? (see pics) - Jiro 17:38:09 03/14/16 no. that can be accessed from the inside to be pounded out. (n/m) - PiotrC70 18:44:35 03/14/16 That's not bad - -Grimm- 18:57:35 03/14/16 No way! - RobZ32 21:20:19 03/14/16 Absolutely! I'll give u $25 for the whole thing (n/m) - ForceFedTT (SoCal) 21:37:24 03/14/16 Not even close. - Goldchocobo 01:18:50 03/15/16
Post a Followup	You cannot reply to this message because you are not logged in.