Subject	Great! Thanks, Kent! If you have one handy, use a micrometer
Posted by	240Z FeO2 on February 21, 2016 at 12:35 AM
	This message has been viewed 278 times.
In Reply To	I'll check and send you an email. posted by ConVerTT on February 20, 2016 at 09:25 PM
Message	to measure the screw diameter. Or a drill bit gauge. Chance favors the informed
Follow Ups	Does anybody have wheel center caps held in with set screws? - 240Z FeO2 11:53:23 02/20/16 how would you tighten them? - LJZTT 12:41:22 02/20/16 You put them on with the wheel off. - Nate (NoVA) 12:45:24 02/20/16 You'd have to tighten the screws from inside the wheel bore - 240Z FeO2 14:22:43 02/20/16 Yes, I have a couple of sets... - ConVerTT 19:52:08 02/20/16 Do you know the set screw diameter? My guess is - 240Z FeO2 20:26:50 02/20/16 6-32 should be sufficient. (n/m) - ZXRider 20:44:01 02/20/16 I'll check and send you an email. - ConVerTT 21:25:18 02/20/16 Great! Thanks, Kent! If you have one handy, use a micrometer - 240Z FeO2 00:35:43 02/21/16 pics - ConVerTT 13:48:07 02/21/16 Perfect!! Thanks and a hat tip. (n/m) - 240Z FeO2 21:39:36 02/21/16 No problem - ConVerTT 00:10:01 02/22/16
Post a Followup	You cannot reply to this message because you are not logged in.