Subject	Yes, I have a couple of sets...
Posted by	ConVerTT on February 20, 2016 at 7:52 PM
	This message has been viewed 297 times.
In Reply To	Does anybody have wheel center caps held in with set screws? posted by 240Z FeO2 on February 20, 2016 at 11:53 AM
Message	They were custom made for my RP01s with an engraved Z logo. I had two sets made just in case. It hasn't been a problem at all. Wheels off, a bit of blue lock tite, easy peasy .... ConVerTT - 93 Hi Compression TT Convertible (black) XtraVerTT - 93 Hi Compression TT Convertible (glacier white) SlickTTop - 96 OBD1 TT Slicktop (black) Old Yeller - 90 Slicktop NA (PGY) And their hot Asian Cousin - 01 Acura NSX NA
Follow Ups	Does anybody have wheel center caps held in with set screws? - 240Z FeO2 11:53:23 02/20/16 how would you tighten them? - LJZTT 12:41:22 02/20/16 You put them on with the wheel off. - Nate (NoVA) 12:45:24 02/20/16 You'd have to tighten the screws from inside the wheel bore - 240Z FeO2 14:22:43 02/20/16 Yes, I have a couple of sets... - ConVerTT 19:52:08 02/20/16 Do you know the set screw diameter? My guess is - 240Z FeO2 20:26:50 02/20/16 6-32 should be sufficient. (n/m) - ZXRider 20:44:01 02/20/16 I'll check and send you an email. - ConVerTT 21:25:18 02/20/16 Great! Thanks, Kent! If you have one handy, use a micrometer - 240Z FeO2 00:35:43 02/21/16 pics - ConVerTT 13:48:07 02/21/16 Perfect!! Thanks and a hat tip. (n/m) - 240Z FeO2 21:39:36 02/21/16 No problem - ConVerTT 00:10:01 02/22/16
Post a Followup	You cannot reply to this message because you are not logged in.