Subject	AEM V1 should support flex-fuel sensor via the
Posted by	LitlElvis on January 03, 2016 at 6:40 PM
	This message has been viewed 484 times.
In Reply To	Need community advice on standalone system. posted by esimplx on January 03, 2016 at 11:33 AM
Message	"user defined fuel trim" (assuming AEMPro for the software). You would need to calibrate the "User #2 fuel trim table" to the flex fuel sensor.
Follow Ups	Need community advice on standalone system. - esimplx 11:33:46 01/03/16 Haltech - WhiTTe Z 13:41:45 01/03/16 Concerns - esimplx 15:23:13 01/03/16 Re: Concerns - ouikikazz 15:47:35 01/03/16 Additionally - induetime 02:02:17 01/04/16 Re: Additionally - esimplx 15:36:45 01/04/16 Haltech can do traction control. You can also look into - MixManMash 16:06:11 01/03/16 Traction control......ish - Madhatter10-6 11:29:17 01/04/16 Re: Traction control......ish - Dallas DamonZ 11:51:47 01/04/16 Re: Re: Traction control......ish - Madhatter10-6 14:57:30 01/04/16 interesting - Dallas DamonZ 15:24:54 01/04/16 Great explanation. Knew you would chime in on this. (n/m) - MixManMash 13:36:32 01/04/16 Great insight - esimplx 13:56:22 01/04/16 AEM V1 should support flex-fuel sensor via the - LitlElvis 18:40:30 01/03/16 Re: AEM V1 should support flex-fuel sensor via the - esimplx 19:10:09 01/03/16 Re: Need community advice on standalone system. - Rob260 04:58:39 01/07/16
Post a Followup	You cannot reply to this message because you are not logged in.