TwinTurbo.NET: Nissan 300ZX forum - Investing in a cheap welder and angle grinder
People Seeking Info
 
   


     
Subject Investing in a cheap welder and angle grinder
     
Posted by Goldchocobo on December 08, 2015 at 2:39 AM
  This message has been viewed 256 times.
     
In Reply To I got burned on my last one because it was rough as hell posted by Muffinz on December 07, 2015 at 03:38 PM
     
Message with cutting discs will pay dividends when tackling rust. Welding with a MIG and is ezpz. And just think of the fabrication possibilities and $ savings.

However, if you don't want to learn these things, GTFO when you see a rusty vehicle.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.