TwinTurbo.NET: Nissan 300ZX forum - Did you replace the EFI harness? If yes and if you depinned
People Seeking Info
 
   


     
Subject Did you replace the EFI harness? If yes and if you depinned
     
Posted by MixManMash on December 02, 2015 at 7:39 AM
  This message has been viewed 363 times.
     
In Reply To I removed the egr vac line and was still getting a slight posted by Evan(CA) on December 02, 2015 at 03:39 AM
     
Message the big white connector, you may have crossed 2 wires which are the same colo (green with yellow IIRC). That can cause the stalling condition as well.

One wire is for speed input to the ECU and the other is for the check engine light (output from ECU).

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.