Subject	Please post back with results when you reinstall the valve
Posted by	ttsmokin on November 08, 2015 at 9:18 PM
	This message has been viewed 221 times.
In Reply To	The 60psi is inside the tree at the cooler output location posted by tiale11 on November 08, 2015 at 08:01 PM
Message	I'm interested to know the difference. From what I understand, when you are hitting the 120psi oil pump relief, it is returning the excess oil back to the sump instead of feeding the pressurized oil gallery? For those with the factory oil cooler setup, at 60psi the valve in the oil filter tree opens and allows oil to flow through the cooler which has a restrictor in one of the lines. This causes some of the oil pressure to be bled off because it returns to the sump. Keeping you from reaching the oil pump relief limit. If you still did not see reduced oil pressures with the valve, would you consider lowering the oil viscosity? I also don't like running over 100psi because my Autometer gauge sender is only rated at 110% of its highest value so its rated to 110psi.
Follow Ups	Engine break in - oil cooler bypass - tiale11 12:27:11 11/03/15 If it's opening up it's because it's designed to do so. - BlackholeZ 15:59:16 11/03/15 Undesirable in the sense that.... - tiale11 17:16:02 11/03/15 Ah, I was thinking that the excess returned to the pan - BlackholeZ 21:51:09 11/03/15 In short, both... - tiale11 09:52:53 11/04/15 Bearing Pictures... - tiale11 09:18:35 11/06/15 Ouch - -Grimm- 15:50:32 11/06/15 Don't be fooled; they're not "ouch". Just shows some - Ashman2k2 11:52:11 11/07/15 ^ that (n/m) - tiale11 17:29:03 11/08/15 I would still consider unfiltered oil and embedded particles - -Grimm- 13:32:22 11/09/15 Do you monitor oil pressures with an aftermarket gauge? - ttsmokin 19:26:15 11/07/15 I was looking through your profile, and I don't see what - Ashman2k2 13:28:19 11/08/15 ^ That. More... - tiale11 17:48:02 11/08/15 Where is the 60psi valve? - ttsmokin 19:14:02 11/08/15 The 60psi is inside the tree at the cooler output location - tiale11 20:01:58 11/08/15 Please post back with results when you reinstall the valve - ttsmokin 21:18:47 11/08/15 I run stock turbos - ttsmokin 19:07:30 11/08/15 About the same oil temps for me as well - tiale11 20:09:35 11/08/15 Eh, not really "about the same" at 20deg higher temp :-) - Ashman2k2 10:49:02 11/09/15 I'm curious, where does that rule come from? - ttsmokin 18:19:48 11/09/15 Those tid bits of data can be misleading - Ashman2k2 11:25:15 11/10/15 Cool, numbers look good. Good thing you went to the higher - Ashman2k2 10:45:58 11/09/15 I am considering running Motul 300V in the future - ttsmokin 18:27:11 11/09/15 Got it. Balanced engine is good :-) (n/m) - Ashman2k2 11:27:40 11/10/15
Post a Followup	You cannot reply to this message because you are not logged in.