Subject	Should be fine (n/m)
Posted by	WhiTTe Z on November 03, 2015 at 6:29 PM
	This message has been viewed 341 times.
In Reply To	Today's $2,500 Question. Drilled into exhaust housing on... posted by ZUL8R on November 03, 2015 at 06:09 PM
Message
Follow Ups	Today's $2,500 Question. Drilled into exhaust housing on... - ZUL8R 18:09:55 11/03/15 Should be fine (n/m) - WhiTTe Z 18:29:02 11/03/15 Gonna go for it. Will report back. Thanks sir. (n/m) - ZUL8R 22:27:49 11/03/15 No significant concern to performance on stockers - OverZealous (CT) 22:58:35 11/03/15 Good call! (n/m) - ZUL8R 15:58:24 11/04/15 do a stud instead...... using a bolt will most likely - Zvil (FL) 13:51:25 11/05/15 FWIW I built a stud out of stainless. It was a big PITA! (n/m) - OverZealous (CT) 21:24:10 11/05/15
Post a Followup	You cannot reply to this message because you are not logged in.