Subject	it's doable I think. No need for block though
Posted by	wickdGSXR on October 26, 2015 at 7:42 PM
	This message has been viewed 292 times.
In Reply To	New Member - New Build Advice posted by USAF_Z32 on October 24, 2015 at 10:16 PM
Message	So your doing bearings, rods & pistons to start? I would do the oversized oil pan as well if you plan on tacking it to the track.
Follow Ups	New Member - New Build Advice - USAF_Z32 22:16:49 10/24/15 You'll spend a lot more than that if you are going to start - ZaXxon 05:25:46 10/25/15 He's right. The best start is to buy a Z that someone has - zellamay 21:03:19 10/25/15 It's over a year old post, might stilll be there? (n/m) - ZUL8TR 07:07:56 10/26/15 it's doable I think. No need for block though - wickdGSXR 19:42:33 10/26/15 Re: it's doable I think. No need for block though - USAF_Z32 21:11:51 10/26/15 Re: Re: it's doable I think. No need for block though - wickdGSXR 22:17:30 10/27/15 Re: New Member - New Build Advice - USAF_Z32 09:15:06 10/27/15 Just go to the vendor websites and start filling your cart - ZaXxon 11:44:56 10/27/15 But you said "stage III", which is nowhere near 500+ , - zellamay 13:44:36 10/27/15 are you in CA? - wickdGSXR 22:21:28 10/27/15 Re: are you in CA? - USAF_Z32 17:04:11 10/28/15 my price range? - wickdGSXR 22:07:51 10/28/15 Contact Specialty Z before you spend $$$$$. (n/m) - Zblackbeast 11:56:03 10/28/15 Re: Contact Specialty Z before you spend $$$$$. - USAF_Z32 17:04:47 10/28/15 yeah I spent $15k with them. Greg won't steer you wrong (n/m) - wickdGSXR 22:08:24 10/28/15
Post a Followup	You cannot reply to this message because you are not logged in.