Subject	continuity test on a MT
Posted by	diamond20601 on October 18, 2015 at 5:21 PM
	This message has been viewed 358 times.
In Reply To	Need a favor. If someone can do a continuity test on a MT posted by Eric(NJ) on October 18, 2015 at 05:10 PM
Message	All that 0 and 1 signify is open and close! You may want to get someone that understands electronic a little better to check behind you. That part you are testing is a simple state part, nothing complex about! With that said it will show nothing else besides 0 and 1.
Follow Ups	Need a favor. If someone can do a continuity test on a MT - Eric(NJ) 17:10:38 10/18/15 continuity test on a MT - diamond20601 17:21:30 10/18/15 Thanks for clarifying how a continuity test works. (n/m) - Eric(NJ) 07:44:43 10/19/15 You will need to spin it in order to test. - ILoveBoost 08:09:22 10/19/15 Are you sure? The service manual says to check for - Eric(NJ) 08:26:23 10/19/15 Continuity wont show you as much as an AC test - -Grimm- 09:26:01 10/19/15 That would be great. Thank you! (n/m) - Eric(NJ) 09:31:04 10/19/15 The FSM is both right and wrong, checking the speed sensor. - DVDBURN (MD) 17:12:13 10/19/15 What Gary said is correct. At 60mph, it should - ILoveBoost 19:04:16 10/19/15 Thanks Gary and Edward. That clears it up. Back to the - Eric(NJ) 19:27:58 10/19/15 Well I finished tracing all the wiring and testing the speed - Eric(NJ) 22:53:07 10/19/15
Post a Followup	You cannot reply to this message because you are not logged in.