Subject	Depends how bent the valves are. Easier to see the bends
Posted by	zxtuner161 on July 30, 2015 at 7:52 AM
	This message has been viewed 313 times.
In Reply To	I am rebuilding a set of heads for the first time and would posted by z32z on July 29, 2015 at 07:10 PM
Message	once you remove them, put them in a drill or or something similar and spin them. You will see small bends that would otherwise be hard to see. Not sure on the manual question so i'll leave that for someone else. **************************************************** "I think its great that I can make a civilized post among you greater life forms only to have my breasts ripped off by savage milk craving z people."
Follow Ups	I am rebuilding a set of heads for the first time and would - z32z 19:10:58 07/29/15 Depends how bent the valves are. Easier to see the bends - zxtuner161 07:52:57 07/30/15 You may be able to notice the material strain - -Grimm- 09:27:11 07/30/15 Thank you for the input. I placed each valve in a drill and - z32z 14:15:48 07/30/15 Most likely thinking of "soft valve" issue w/ 90 (n/m) - FrozTTy 10:25:46 07/30/15 Re: Most likely thinking of "soft valve" issue w/ 90 - wild_maxx 14:34:29 07/30/15 This is great info. Thanks. - z32z 15:45:10 07/30/15 Why not have the machine shop measure the valves? - zellamay 14:28:43 07/30/15 Lap valves - EngineerLV 21:05:31 07/30/15 Not necessarily true - ZXoltan 06:13:25 07/31/15
Post a Followup	You cannot reply to this message because you are not logged in.