Subject	correct...
Posted by	Madhatter10-6 on June 30, 2015 at 2:56 PM
	This message has been viewed 578 times.
In Reply To	yes the ECu IS grounding it but there is still current posted by kickerzx on June 30, 2015 at 12:52 PM
Message	I should have clarified a little further. The Haltech isn't providing power to the unit like it does a DBW setup or an idle control unit...thats what I was trying to explain in the previous post :) The DPO channels can handle 1amp max [ http://files.haltech.com/downloads/ESP/Elite_2500_Wiring_Diagram_v2.pdf ] The Mac boost solenoids are rated at 5.4 watts, 0.24-.4 ohm coil, .45 amps @ 12 volts Madhatter10-6
Follow Ups	Haltech Platinum pro boost control with a Blitz solenoid - MeatMan 23:53:30 06/29/15 No, but I used 2 Haltech solenoids driven off the same - MixManMash 07:37:05 06/30/15 To add, once Seb tuned and got closed loop boost control - MixManMash 07:54:34 06/30/15 My sbcid3 has been very consistent and reliable! - MeatMan 15:19:34 07/01/15 I had a SBC icolor. It too was reliable. - MixManMash 05:01:25 07/02/15 do you have 1 solenoid per turbo? (n/m) - aliaZ 12:13:01 06/30/15 Yes. (n/m) - MixManMash 18:48:55 06/30/15 The ECU isn't powering the boost solenoid - Madhatter10-6 09:00:57 06/30/15 yes the ECu IS grounding it but there is still current - kickerzx 12:52:16 06/30/15 correct... - Madhatter10-6 14:56:35 06/30/15
Post a Followup	You cannot reply to this message because you are not logged in.