Subject	yes the ECu IS grounding it but there is still current
Posted by	kickerzx on June 30, 2015 at 12:52 PM
	This message has been viewed 455 times.
In Reply To	The ECU isn't powering the boost solenoid posted by Madhatter10-6 on June 30, 2015 at 09:00 AM
Message	running through the ground wire. There is probably info in the manual about what the max amount of current you can draw through each output. If you ohm the solenoid it is easy to figure out what kind of amperage it will draw. Can the ecu handle twice that? Probably. You just need to check with the manual. U=I*R and P=U*I However as the hatter said. MAC valves are cheap...
Follow Ups	Haltech Platinum pro boost control with a Blitz solenoid - MeatMan 23:53:30 06/29/15 No, but I used 2 Haltech solenoids driven off the same - MixManMash 07:37:05 06/30/15 To add, once Seb tuned and got closed loop boost control - MixManMash 07:54:34 06/30/15 My sbcid3 has been very consistent and reliable! - MeatMan 15:19:34 07/01/15 I had a SBC icolor. It too was reliable. - MixManMash 05:01:25 07/02/15 do you have 1 solenoid per turbo? (n/m) - aliaZ 12:13:01 06/30/15 Yes. (n/m) - MixManMash 18:48:55 06/30/15 The ECU isn't powering the boost solenoid - Madhatter10-6 09:00:57 06/30/15 yes the ECu IS grounding it but there is still current - kickerzx 12:52:16 06/30/15 correct... - Madhatter10-6 14:56:35 06/30/15
Post a Followup	You cannot reply to this message because you are not logged in.