Subject	The ECU isn't powering the boost solenoid
Posted by	Madhatter10-6 on June 30, 2015 at 9:00 AM
	This message has been viewed 506 times.
In Reply To	Haltech Platinum pro boost control with a Blitz solenoid posted by MeatMan on June 29, 2015 at 11:53 PM
Message	With Haltech's (and most other standalones) the ECU is only outputting the ground signal. [ http://www.haltech.com/wp-content/uploads/2011/01/HALTECH-BOOST-CONTROL-SOLENOID.pdf ] So you could have it run two solenoids if you wanted. Regarding the Blitz solenoid Im sure you could but I don't know why you would want to. Haltech and most other companies just use Mac Boost Solenoids [ http://www.ebay.com/sch/i.html?_from=R40&_trksid=p2050601.m570.l1311.R1.TR1.TRC0.A0.H0.Xmac+boost+sol.TRS0.G%7C1%7C0&_nkw=mac+boost+solenoid&_sacat=0 ] They are very cheap and easy to wire up. Madhatter10-6
Follow Ups	Haltech Platinum pro boost control with a Blitz solenoid - MeatMan 23:53:30 06/29/15 No, but I used 2 Haltech solenoids driven off the same - MixManMash 07:37:05 06/30/15 To add, once Seb tuned and got closed loop boost control - MixManMash 07:54:34 06/30/15 My sbcid3 has been very consistent and reliable! - MeatMan 15:19:34 07/01/15 I had a SBC icolor. It too was reliable. - MixManMash 05:01:25 07/02/15 do you have 1 solenoid per turbo? (n/m) - aliaZ 12:13:01 06/30/15 Yes. (n/m) - MixManMash 18:48:55 06/30/15 The ECU isn't powering the boost solenoid - Madhatter10-6 09:00:57 06/30/15 yes the ECu IS grounding it but there is still current - kickerzx 12:52:16 06/30/15 correct... - Madhatter10-6 14:56:35 06/30/15
Post a Followup	You cannot reply to this message because you are not logged in.