Subject	i would suggest doing some measurements (od) before drilling
Posted by	itsa300zx on June 16, 2015 at 8:54 PM
	This message has been viewed 166 times.
In Reply To	That will be strong enough? (n/m) posted by Nis300owner on June 16, 2015 at 05:18 PM
Message	the holes for the helicoils. By the time you drill and tap to fit the helicoils, there may not be enough "meat" left for the coils to bite onto. I'm not 100% sure, but from what I remember, there are just threaded nuts on the other side of the trans mount. Some else will need to confirm.
Follow Ups	Brain storming - Nis300owner 16:31:33 06/16/15 Re: Brain storming - njz 16:56:16 06/16/15 That will be strong enough? (n/m) - Nis300owner 17:18:27 06/16/15 It will be stronger than standard threads - -Grimm- 17:34:44 06/16/15 Boo this :-) (n/m) - Bernie (NoVA) 17:46:16 06/16/15 Is there supposed to be a nut or something - Nis300owner 18:29:50 06/16/15 They thread into & from the block & gussets. (n/m) - Bernie (NoVA) 19:56:52 06/16/15 ???, I think you are confused with the bell housing bolts. - itsa300zx 20:43:23 06/16/15 I used 6mm-10x1.25 time-serts to repair my mount threads. (n/m) - Zebszx 07:12:18 06/17/15 i would suggest doing some measurements (od) before drilling - itsa300zx 20:54:07 06/16/15 There are many Aircraft applications - BlackholeZ 11:51:19 06/17/15
Post a Followup	You cannot reply to this message because you are not logged in.