Subject	TwinZ rear V2 bumper install issues.
Posted by	PiotrC70 on May 22, 2015 at 9:32 PM
	This message has been viewed 537 times.
Message	Search didn't turn up anything so this leaves me wondering... I'm test fitting before tomorrows repaint and patience is thin. I've installed the factory mounting supports as follows. Center, then center left/right, then outside pieces. It almost appears as if the mufflers have to be removed but with the brackets snapped in all the way, they appear to sit low on the provided cutouts. Due to the fiberglass tab near the tires, I cant get both around around the factory welded support and still get all my bolts in. Am I missing something here? 1993 TT. R.I.P. 09.15.2010
Follow Ups	TwinZ rear V2 bumper install issues. - PiotrC70 21:32:28 05/22/15 Pics of my issues - PiotrC70 21:53:34 05/22/15 Re: Pics of my issues - diamond20601 02:49:04 05/23/15 Neither. Bumper has never been replaced. I have a scuff on - PiotrC70 10:47:32 05/23/15 After opening up the two outer holes, and using a flathead - PiotrC70 17:50:35 05/23/15 You may have to do some trimming - DAYTONAZ 18:12:41 05/23/15 Thanks for the tip on dropping the exhaust, it's been so - PiotrC70 17:28:12 05/24/15 Re: Neither. Bumper has never been replaced. I have a scuff on (n/m) - diamond20601 21:46:50 05/24/15 ran into the same issues. - RobZ32 15:23:27 05/23/15 Thanks, I guess, my winter project, any tips, helpful. (n/m) - Z ONLY1 08:50:00 05/26/15
Post a Followup	You cannot reply to this message because you are not logged in.