Subject	It happens with Zs. Projects get long
Posted by	BlackholeZ on April 15, 2015 at 1:24 PM
	This message has been viewed 401 times.
In Reply To	Thanks for mentioning that. It's encouraging because mine posted by Zuberman on April 14, 2015 at 11:10 PM
Message	Be sure to squirt some oil in the cylinders before you try to turn the motor. (even on the stand) Give it an oil change before you really lay into it when you get it running again. Doesn't have to be a full 3k oil change, think of it as a rinse. 1-2 weeks to rinse out the old oil. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Compression - pearlzed(toronto) 20:45:47 04/14/15 130 is a bit low - Zbullet 21:06:49 04/14/15 The cylinder that was low was - pearlzed(toronto) 22:04:28 04/14/15 I think the numbers are ok given conditions, they should eve - Bernie (NoVA) 08:44:41 04/15/15 Thx I was hoping you would chime in on that. - pearlzed(toronto) 08:52:47 04/15/15 EFI harness stays in the bay. Be gentle or expect to replace (n/m) - Bernie (NoVA) 21:26:16 04/14/15 I had low numbers on 5&6 - BlackholeZ 22:19:40 04/14/15 Thanks for mentioning that. It's encouraging because mine - Zuberman 23:10:04 04/14/15 It happens with Zs. Projects get long - BlackholeZ 13:24:37 04/15/15 Ok, awesome, thanks! Probably not news to a veteran like you - Zuberman 13:46:27 04/15/15 Most people use ATF for the same thing - BlackholeZ 15:20:49 04/15/15
Post a Followup	You cannot reply to this message because you are not logged in.